NF DP Series - Check before Use; Table 2-1 List of Content

2. Preparation before Use
PROGRAMMABLE AC POWER SOURCE
10
2.1 Check before Use
Check the safety.
To ensure equipment operator's safety, be sure to read the following sections of the instruction
manual.
 Safety Precautions (Page ii)
 2.4 Grounding and Power Connections
Check the appearance and contents.
If there is any problem, contact the seller (NF Corporation or our agent) from whom you purchased
this product.
 Appearance check
Make sure that there is no damage or dent made during the transportation on the LCD screen,
keys, jog, or shuttle of the control panel, or rear connectors.
 Contents (main unit and accessories) check
The contents are listed in Table 2-1. Make sure that all of the main unit and accessories are
included.
Table 2-1 List of Content
Content Quantity
Main unit Main unit 1
Accessories
Instruction Manual 1
CD-ROM
Contents: Control Software for DP Series, LabVIEW Driver,
Instruction Manual (Remote Control), Control Software for
DP Series Instruction Manual
1
Ferrite core (large) (multi-phase model only) 2
Ferrite core (small) (multi-phase model only) 1
Cable tie (multi-phase model only) 2
Stabilizer (only for DP series model of 7.5 kVA or higher and
DP series Type R model of 6 kVA or higher)
1
Note: Refer to Figure 2-2 and assemble the stabilizer, because it is necessary to ensure stability of DP series
and DP series Type R.