4.28 Restoring to the Factory Default Setting (Reset)
DP Series/DP Series Type R
213
Table 4-16 Setting Items to be Reset (Continued)
Setting Item Reset Factory default setting
Phase angle setting
Single-phase three-wire: 180 deg
Three-phase: 120, 240 deg
Balanced/Unbalanced
Balanced
DC voltage setting
0 V
Current limiter
Refer to 10.13
Setting range limit
Refer to 10.14
External input gain
0
Phase to be measured
L1
Output function
Continuous
DC offset × 0 mV
Measurement display mode
Normal
Measurement unit selection
rms
Power unit energization setting × All enabled (energization)
Remote sensing
Off
AGC
Off
Autocal
Off
CO
2
internal loss integration value × 0.000000 tCO
2
CO
2
output power integration value × 0.000000 tCO
2
Emission CO
2
coefficient × 0.000555 tCO
2
/kWh
LCD display × Blue tone
Beep
On
Key lock
Off
Output relay control
Enable
Output setting at power-on
Off
Trigger output setting
Negative, 10 ms
Time unit
s
Monitor output target
Current (L1 phase)
External interface × USB
External control × Disable
Clipped sine wave
Clip ratio specified
Clip ratio: 100%
Crest factor: 1.41
Arbitrary Waveform Memory × ARB1 to 8: Triangle wave
ARB9 to 16: Square wave
To Next Page
Loading...