8-7
8
ERROR MESSAGES AND ACTIONS
8) In Settings
Any of the following JOB settings is
changed.
>1:Angle>>VA zero, HA to BS
>2:Dist>>Scale, T-P, Sea Lvl, C&R
>3:Coord>>Coord, Az zero
>5:Unit>>Angle, Dist, Temp, Press
[4:OK]/[ENT]=closes the current Job. The change of the
setting is completed.
[1:Abrt]/[ESC]=cancels the change in the Job settings. The
current job remains to open.
9) Data
A Job is not opened yet.
[1: Select Job]=goes to Job list if there is any existing job.
[2: Create Job]=displays a new job creating screen.
[3:Abort]/[ESC]=returns to the previous screen.
When attempting to delete a ST record by
[1:RAW data]/[2:XYZ data] [MENU]
[1:DEL]:
Action : Press any key to return to the
Data view screen.
！Ｃａｎ’ｔ Ｄｅｌｅｔｅ
ＳＴ ｃａｎｎｏｔ ｂｅ
ｒｅｍｏｖｅｄ．
Ｐｒｅｓｓ ａｎｙ ｋｅｙ
When the Job setting is changed by [4:OK] or [ENT] on this
screen, you can use the new setting afterwards, however, to record
the point, you need to create a new JOB with those settings.
！Ｊｏｂ Ｓｅｔｔｉｎｇｓ
Ｃｈａｎｇｅｄ
Ｊｏｂ ｗｉｌｌ ｃｌｏｓｅ
Ａｂｒｔ ＯＫ
！Ｎｏ Ｏｐｅｎ Ｊｏｂ
１：Ｓｅｌｅｃｔ Ｊｏｂ
２：Ｃｒｅａｔｅ Ｊｏｂ
３：Ａｂｏｒｔ
To Next Page
Loading...
