17
PROCEDURES
Procedure 1: Connecting a PC to the laser using a USB cable ...................... 46
Procedure 2: Turning ON the laser.................................................................. 48
Procedure 3: Turning OFF the laser................................................................ 49
Procedure 4: Relocating panels ...................................................................... 52
Procedure 5: Using the Key Updater tool........................................................ 58
Procedure 6: Using the Log Downloader......................................................... 59
Procedure 7: Connecting the door interlock circuit.......................................... 77
Procedure 8: Connecting power...................................................................... 78
Procedure 9: Installing the Collimator.............................................................. 79
Procedure 10: Installing CONTROL ............................................................... 107
To Next Page
Loading...
