Safety
1-12
E 2015 Nordson Corporation
Issued 10−11
Table 1‐2Safety Labels and Tags
Item Part Description
1. — Warning, CE, hot (screen print)
2. — Warning, CE, electrical shock (screen print)
3. — Warning, CE, pressure (screen print)
4. — Warning, CE, pressure, drain valve (screen print)
5. 243352
WARNING: Fire, injury or equipment damage can result if cleanout
materials do not meet the following requirements:
1. Minimum flash point to be 550 _F (288 _C).
2. Liquid and vapor to be non‐toxic at use temperature in
equipment.
3. Chemical reactions with adhesive and equipment materials
must not be violently heat producing.
4. Cleanout material must not corrode or otherwise weaken
equipment materials.
CAUTION: This equipment is factory tested with Nordson type R fluid
containing Polyester Adipote plasticizer. Certain adhesives may react
with the type R fluid residue to form solid gum which can be difficult to
remove.
To avoid equipment damage check with adhesive supplier regarding
compatibility and cleanout procedure before putting adhesive into the
system.
600103
CAUTION: This unit is equipped with ______ _F preset thermostat.
Use only adhesive formulated for application at this temperature.
Before changing adhesive consult instruction manual for changing
operating temperature. Failure to follow instructions may result in
personal injury or property damage.
CAUTION: This gun is RTD (resistance temperature detector)
controlled. Prior to operation and before changing adhesive consult
instruction manual for changing operating temperature. Failure to follow
instructions may result in personal injury or property damage.
600137
WARNING: Disconnect power and remove system pressure before
disassembly or maintenance. Failure to follow these instructions may
result in serious personal injury.
To Next Page
Loading...
Need help?
General
