Installation
3-4
Part 1079832_04
E 2015 Nordson Corporation
Hose Installation
Follow this procedure for each hose hydraulic connection you are making. Do
not connect the hose cordsets at this time.
1. Connect the hose to the adhesive supply port on the applicator, using a
hose fitting as necessary. Use two wrenches to connect the hose as
shown in Figure 3‐2.
NOTE: The hose cordset should be located at the melter end (where
adhesive enters the hose). This ensures that the hose sensor measures
the temperature of the adhesive exiting the hose.
NOTE: Refer to the parts section of the melter manual for available hose
fittings.
2. Install the insulation cuff from the ship‐with kit over the hose connection.
CAUTION! Risk of equipment damage. Do not use nonconductive pipe
compound or tape on hose fittings.
CAUTION! Improper routing and venting of hoses could result in
overheating, damage, and poor adhesive flow. To ensure proper operation,
do not bundle or tie‐wrap hoses, do not bend hoses at sharp angles, and do
not allow hoses to lay on concrete floors or other cool surfaces that could
conduct heat away from the hoses.
3. Route the hose to the melter and connect it to the melter hydraulically
and electrically as directed in the melter manual. Follow the hose routing
guidelines shown in Figure 3‐2.
To Next Page
Loading...
Need help?
General
