Operation
4-1
Part 1079832_04
E 2015 Nordson Corporation
Section 4
Operation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Introduction
This section provides procedures for operating the applicator. Before you
operate the applicator for the first time, make sure you have
S completed the installation procedures in Section 3, Installation
S flushed the applicator by completing the applicator flushing procedure
in Section 3, Installation
S optimized the applicator output for your application as described in
Applicator Testing in Section 3, Installation
Before you perform any operating procedures, review Section 1, Safety.
Startup and Shutdown
Because the melter supplies the adhesive and the electrical power to the
applicator, the procedures for starting and stopping the applicator vary
depending on the type of melter you are using. Refer to the melter manual for
complete startup and shutdown procedures.
To Next Page
Loading...
