Nordson Universal Series - Solenoid Valves; Specifications

Description
2-9
Part 1079832_04
E 2015 Nordson Corporation
Solenoid Valves
The solenoid valve is integral to the module, as shown in Figure 2‐5.
Solenoid valves are used to control the module‐actuating air. They are
pneumatically connected to a clean, dry, unlubricated air supply and
electrically connected to a triggering device. The triggering device causes
the solenoid valves to open and close at the appropriate times, which in turn
causes the modules to open and close to dispense adhesive in the desired
pattern.
The solenoid valves on your applicator will be one of two types: boosted or
non‐boosted. Figure2‐5 shows the two types of solenoid valve. For more
information on solenoid valves, refer to Section9, Module.
Specifications
The applicator specifications vary depending on the type of module installed
on the applicator. Refer to Applicator Specifications in Section 9, Module, for
the applicator specifications.