Installation
3-1
Part 1079832_04
E 2015 Nordson Corporation
Section 3
Installation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Introduction
This section provides procedures for installing the applicator and preparing it
for operation. Before performing any installation procedures, review
Section1, Safety.
Unpacking
Exercise normal care to prevent equipment damage during unpacking. After
unpacking the applicator, inspect if for any damage that may have occurred
during shipping. Look for any dents and scratches and make sure all
fasteners are tight. Report any damage to your Nordson representative.
Items Needed
You will need the following items to install the applicator:
S melter or temperature controller, hoses, and associated manuals
S electronic control device for solenoid valves
S air line tubing and fittings
S applicator mounting hardware
S device to lift and position the applicator
S personal protective equipment for working with hot adhesive
S toolkit, including wrenches and screwdrivers
S anti‐seize lubricant
S drain pans and waste containers suitable for waste adhesive
S PTFE paste or tape
To Next Page
Loading...
Need help?
General
