Repair
7-1
Part 1079832_04
E 2015 Nordson Corporation
Section 7
Repair
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Introduction
Repair procedures for the applicator are located in Sections 9–11 as shown
in Table 7‐1. Follow these guidelines when making any repair:
S Review Section 1, Safety, before beginning the repair.
S Have the required tools, supplies, and replacement parts on hand.
They are listed at the beginning of each repair procedure. Refer also
to Section 5, Maintenance, for a list of required tools and supplies.
Refer to Section 8, Parts, or to Parts in Sections 9–11 for replacement
part numbers.
S Relieve system pressure and disconnect and lock out electrical
power to the system before performing any repair.
Location of Repair Procedures
Because applicator configurations vary, repair procedures are located in
Sections 9–11, which are specific to your applicator. Table7‐1 shows the
location of the repair procedures in this manual.
Table 7-1 Location of Repair Procedures
Procedure Location
Replacing a module
Removing or installing a nozzle
Section 9, Module
Replacing a filter screen Section 10, Filter
Replacing a heater
Replacing a sensor
Section 11, Electrical System
To Next Page
Loading...
Need help?
General
