Maintenance
5-1
Part 1079832_04
E 2015 Nordson Corporation
Section 5
Maintenance
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Introduction
This section contains a list of recommended maintenance activities and a
recommended schedule for performing those activities. Attempting any other
maintenance procedures can result in equipment damage, improper system
operation, or personal injury.
Before you perform any maintenance procedures, review Section 1, Safety.
Required Tools and Supplies
To perform maintenance or repairs, you will need:
S a set of metric socket wrenches
S a set of metric Allen (hex) wrenches
S a set of metric T‐handle hex keys
S a set of metric open‐ended wrenches
S flat‐blade and Phillips‐head screwdrivers
S drain pans and large waste containers
S other tools and supplies as noted
You will also need a sufficient inventory of spare parts and supplies. Each
maintenance and repair procedure in this manual is preceded by a list of the
parts and supplies you will need. Refer to Section 8, Parts, and to Parts in
Sections 9–11 for the part numbers of parts and supplies.
To Next Page
Loading...
Need help?
General
