Nortel 2004 - Page 19

About the Nortel IP Phone 2004
19
Your Mute key functionality is enabled or
disabled by your system administrator.
Contact your system administrator to
determine if your Mute key is enabled.
If your Mute key is enabled, press the Mute
key to listen to the receiving party without
transmitting your voice. Press the Mute key
again to return to two-way conversation.
Note: If your Mute key is not enabled,
pressing the Mute key places the call on
hold. Press the Mute key again to
restore the active call or press the line
key to restore the active call. You cannot
retrieve this call from hold by pressing
the Hold key.
The Mute key applies to handsfree,
handset,and headset microphones.
The Mute LED indicator, located on the Mute
key, flashes to indicate that the microphone
is muted.
Press the Quit key to end an active
application. Pressing the Quit key does not
affect the status of calls currently on your
telephone.
Context-sensitive soft keys (self-labeled)
are located below the LCD display screen.
The LCD label above the key changes based
on the active feature.
Note: If a triangle appears before a soft
key label, the feature is active.
(Mute)
(Quit)