Nortel 2004 - Additional Call Features

Additional call features
92
Additional call features
Contact your system administrator to determine if the following call
features are available on your telephone.
• “Using AutoDial Transfer” on page 92
• “Using the Buzz signal” on page 93
• “Using Call Page Connect to make an announcement” on page 93
• “Using Centrex/Exchange Line Switchhook Flash” on page 94
• “Charging a call or charging a forced call” on page 95
• “Using Enhanced Override” on page 98
• “Using Forced Camp-on feature” on page 99
• “Overriding a busy signal” on page 100
• “Using Privacy Release” on page 101
• “Using Radio Page” on page 102
• “Using Voice Call” on page 104
Using AutoDial Transfer
Use the AutoDial Transfer feature to transmit digits through your AutoDial
key to the Central Office after a Trunk Switchhook Flash. You must be on
a Central Office/Exchange (CO) trunk call from or to a Central Office (CO)
that offers Centrex or exchange line-type features.
To use AutoDial Transfer when picking up an incoming trunk call:
1. Press the Centrex Switchhook Line
Flash key and wait for interrupted dial
tone.