Nortel CS 1000 User Manual

164 System configuration
2 Select Dialing & Numbering plans > Network Routing
Service.
3 Enter the TLAN address of the Signaling Server.
4 Click Next.
--End--
Use the steps in these procedures to configure the NRS.
•
Procedure 74 “Setting the database to standby view” (page 164)
•
Procedure 75 “Creating service domain” (page 165)
• Procedure 76 “Adding the UDP domain” (page 165)
• Procedure 77 “Adding the CDP domain” (page 165)
• Procedure 78 “Adding Gateway Endpoint for the signaling server ”
(page 166)
• Procedure 79 “Adding Gateway Endpoint for DAP redirect server”
(page 167)
• Procedure 80 “Configuring routing entries for DAP Redirect Server”
(page 168)
• Procedure 81 “Configuring routing entries for the signaling server”
(page 169)
•
Procedure 82 “Saving changes” (page 170)
Setting the database to standby view
The Configuration tab is used to configure NRS for actions such as
adding a service domain, L1 (UDP) and L0 (CDP) domains, adding
gateway endpoints, or adding routing entries. Set the database to Standby
Database view in order to make changes.
Follow the steps in the next procedure to set the database to standby view.
Procedure 74
Setting the database to standby view
Step Action
1 Select Configuration from the tool bar at the top of the page.
A dialog box indicating the status of Active and Standby
database is displayed.
2 Click OK.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.

Nortel CS 1000 Specifications

General

Brand	Nortel
Model	CS 1000
Category	Server
Language	English