[Number of sets]
Setting Values Description
[Number of sets] [Check first set] When the [Check first set] setting is enabled,
the printer stops after the first set of a job has
been printed. You can check the quality of the
output.
NOTE
This setting is only available when in
the workflow profile [Check first set]
is set to [As in job].
[Number of sets] You can indicate how many copies of the job
you need. You can enter a value from 1 -
65,000. The default value is 1.
Job Name
Setting Values Description
[Job name] To identify your job more easily, you can change
the name of the job. When you touch the [Job
name] button a keyboard appears. Then you can
change the name of the job.
[Page range]
Setting Values Description
[Page range] [All] When [All] is selected, all pages of the job will
be printed.
[Page range] When [Page range] is selected, use the [From]
and [To] fields to indicate the first and last pa-
ges you want printed.
[Separator sheets]
Setting Values Description
[Separator sheets] [On] When the [Separator sheets] setting is ena-
bled, a separate sheet is inserted automatically
before each set of a job to create a clear dis-
tinction between two sets. Separator sheets
are always empty. In the Settings Editor, select
a media from the media catalog use as separa-
tor sheets. You can also indicate the feed di-
rection of the separator sheets (long-edge feed
or short-edge feed).
[Off] No separator sheet will be inserted before
each set.
Description of the print job settings that you can change on the control panel
Chapter 9 - Carry out print jobs
141
Océ VarioPrint 6000 line
To Next Page
Loading...
