Step Actions on the print‐
er
Actions on the host Remarks
3 Change the active
PDL when currently
the wrong PDL is ac-
tive. This is only pos-
sible when you have
licenses for more
than 1 PDL.
Via the Settings Editor: [Transac-
tion printing] -> [Setups] -> [Re-
quested active PDL].
4 Load the required
media into the paper
trays.
Only required when the active set-
up has set the tray mode to tray to
tray.
5 Put the printer on-
line.
• Via the control panel: [System] -
> [Transaction] -> [Transaction
online] -> [On], or
• Via the Settings Editor: [Trans-
action printing] -> [Settings] ->
[Switch the printer online or off-
line].
6 Connect to the printer.
7 Submit the transaction
print jobs.
8 Print the transaction
print jobs.
You must perform all the regular
activities, for example load the
media, empty the output locations,
add the supplies and solve errors.
9 Put the printer off
line when the trans-
action print jobs are
ready.
• Via the control panel: [System] -
> [Transaction] -> [Transaction
online] -> [Off], or
• Via the Settings Editor: [Trans-
action printing] -> [Settings] ->
[Switch the printer online or off-
line].
10 Switch the printer
back to the docu-
ment printing mode.
• Via the control panel: [System] -
> [Transaction] -> [Transaction
printing mode] -> [Off].
Introduction to the [Transaction] section
178
Chapter 9 - Carry out print jobs
Océ VarioPrint 6000 line
To Next Page
Loading...
