viii
Introduction
F3SJ-A
User’s Manual
Other
To use the F3SJ in PSDI mode (Reinitiation of cyclic operation by the protective equipment), you
must configure an appropriate circuit between the F3SJ and the machine. For details about
PSDI, refer to OSHA1910.217, IEC61496-1, and other relevant standards and regulations.
Do not try to disassemble, repair, or modify this product. Doing so may cause the safety functions
to stop working properly.
Do not use the F3SJ in environments where flammable or explosive gases are present. Doing so
may result in explosion.
Perform daily and 6-month inspections for the F3SJ. Otherwise, the system may fail to work
properly, resulting in serious injury.
To Next Page
Loading...
