Omron MX2 Series - Monitor Mode; Group D

4 - 2
Multi-function Compact Inverter 3G3MX2-EV2 User’s Manual (I666-E1)
4 Parameter List
4-1 Monitor Mode
The inverter by default displays the data of the parameter d001 after power-on. To monitor the desired
parameter at power-on, change this default setting in the Initial Screen Selection (b038).
The displayed parameters vary with the Display Selection (b037) setting. To display all parameters, set
this parameter to 00 (Complete display).
For data that exceeds the display digits of the Digital Operator, the upper digits of the data are dis-
played. To monitor digits that are not displayed, use the digit shift display mode. For details, refer to
Digit Shift Display Mode on page 3-11.
4-1-1 Group d
Parameter
No.
Function name
Monitor or data range
Default
data
Changes
during
RUN
Unit
Page
d001
Output Frequency
Monitor
0.00 (0.0) to 590.00 (590.0)
*1
−
Enabled
Hz
P. 7-4
d002
Output Current Moni-
tor
0.00 to 655.35
−
−
A
P. 7-4
d003
RUN Direction Moni-
tor
F: Forward
o: Stop
r: Reverse
−
−
−
P. 7-5
d004
PID Feedback Value
Monitor
0.00 to 9999.00
*2
−
−
−
P. 7-5
ON
d005
Multi-function Input
Monitor
*3
OFF
EA 7 6 5 4 3 2 1
(Example)
−
−
−
P. 7-5
Terminals 1, 2: ON
Terminals 3 to 7: OFF
d006
Multi-function
Output Monitor
ON
OFF
AL 12 11
(Example)
Terminals 11, 12: ON
Terminal AL: OFF
−
−
−
P. 7-6
d007
Output Frequency
Monitor (After Con-
version)
0.00 (0.0) to 58994.10 (58994.1)
*1
−
Enabled
−
P. 7-6
d008
Real Frequency
Monitor
−590.00 (−590.0) to 590.00 (590.0)
*1
−
−
Hz
P. 7-7
d009
Torque Reference
Monitor
0 to 200
−
−
%
P. 7-7
*1. In high-frequency mode.
*2. The digit shift display mode can be used.
*3. Turning ON the EDM function selector switch automatically switches the input status display of 3 and 4 to the
input status display of GS1 and GS2. Although 3 and 4 cannot be monitored with d005 when the EDM function
selector switch is ON, the terminals operate according to the selected function.