Opticon L-46X - Read Time Settings

Chapter-8
Read Options
L-46X User's Manual
99
1st
Read Time
8.1.2
Read time setting sets the reading time of 1 reading operation. After trigger signal is on, or when the
readout command “Z” is sent, readout operation starts. If no data outputted within the specified time,
the readout operation stops.
Item
Command
Description
Default
Remark
Read time
setting
Y0
Using trigger key
Auto trigger
: Synchronized with trigger key
: Auto

*
Y1
1 second
Y2
2 seconds
Y3
3 seconds
Y4
4 seconds
Y5
5 seconds
Y6
6 seconds
Y7
7 seconds
Y8
8 seconds
Y9
9 seconds
YM
Read time infinite
YL
Read time 10 times
* When auto trigger with “Y0”, read time is automatically set by the image processing.
* When auto trigger read time is auto, read time can be adjusted in 8.3.4.