Opticon L-46X - Start-Up Buzzer; Read Timeout Buzzer; Intermediate Buzzer

Chapter-4
Indicator Options
L-46X User's Manual
29
1st
Start-up Buzzer
4.1.3
This setting determines whether the scanner emits a beep when it is powered on.
Item
Command
Description
Default
Remark
Startup buzzer
GD
Disable startup buzzer
Enabled only
with “Z2”
GC
Enable startup buzzer

Enabled only
with “Z2”
Read Timeout Buzzer 4.1.4
In case a code is not read within the timeout period, an error buzzer sounds when the read operation
ends.
Item
Command
Description
Default
Read timeout
buzzer
[EAP
Disable read timeout buzzer

[EAQ
Enable read timeout buzzer
Intermediate Buzzer 4.1.5
When one code is decoded, an intermediate buzzer sounds to indicate that the code is decoded but it
does not yet meet the conditions to output data.
For instance, suppose five-codes reading is set in buffer mode, the intermediate buzzer then sounds
after the decoding of the 1st, 2nd, 3rd and 4th code and a good read buzzer finally sounds when the
last code is decoded after which the data is output. The data is not output when the 1st to 4th codes
are decoded but reading of each code can be confirmed by the intermediate buzzer. When the good
read buzzer is disabled, this setting will be forcibly disabled.
Item
Command
Description
Default
Intermediate buzzer
[EBY
Q0
Disable intermediate buzzer
Q1
Enable intermediate buzzer

* Intermediate buzzer frequency: 5000 Hz (5 KHz), duration: 10 ms