Opticon L-46X - Common Settings for All Interfaces

Chapter-5
Interface
L-46X User's Manual
52
1st
Common Settings
5.4
This section describes the settings common to all interfaces.
Data Buffer Mode 5.4.1
This option allows you to specify whether to read an object during data output.
When buffer mode is enabled, the scanner can perform other operations such as barcode scanning
while outputting decoded data. However, the reading performance may degrade during the data
output. When buffer mode is disabled, the scanner stops other operations until the completion of
decoded data output.
The following menu codes / commands are provided for the data buffer mode setting.
Item
Command
Description
Default
Data buffer mode
[D80
Data buffer disable
[D81
Data buffer enable *

* When handshaking is configured, this setting is ignored and Data Buffer Mode is disabled.