Itala | INSTRUCTION MANUAL
the SequencerSetSelector. After the user has changed all the needed camera settings it is possi-
ble to store all these settings within a selected sequencer set by SequencerSetSave. The user can
also read back this settings by SequencerSetLoad.
To permit a flexible usage, up to two paths are available to go from one sequencer set to another.
Such a path is selected by SequencerPathSelector. Each path and therefore the transition be-
tween different sequencer sets is based on a defined trigger and an upcoming targeted sequencer
set which is selectable by SequencerSetNext. After the trigger occurs the settings of the next set
become active.
The trigger is defined by the features SequencerTriggerSource (Table 41) and SequencerTrig-
gerActivation.
NOTE: SequencerTriggerActivation is set to "RisingEdge" by default and cannot be changed.
A sequencer set should contain the following values:
• Camera data which should be controlled by the device
• SequencerPathSelector with at least one path
• SequencerSetNext, SequencerTriggerSource and SequencerTriggerActivation for every
path which is selectable by the SequencerPathSelector.
NOTE: If two paths are configured, Path 0 has a higher priority than Path 1. If two different
SequencerTriggerSource occur at the same time, the trigger source associated with Path 0 wins.
The following features are currently available to be used inside the Sequencer Control:
Feature Note
ExposureTime
CounterDuration Only Counter0 is configured
OffsetX A proper ROI must be pre-configured
OffsetY A proper ROI must be pre-configured
Gain
oeLiquidLensCurrent oeLiquidLensMode must be set in CurrentMode
oeLiquidLensPower oeLiquidLensMode must be set in PowerMode
Table 40: Available features for Sequencer Control operations
SequencerTriggerSource values supported by Itala cameras are:
Feature Note
v1.12 - eng 111
To Next Page