range Pi User Manual Copyright reserved by Shenzhen Xunlong Software Co., Ltd
56
Note, if you upload a .7z or .xz or .gz Linux image compressed file, please
remember to decompress it before using the dd command to burn.
The detailed description of all parameters of the dd command and more usage
can be viewed by executing the man dd command in the Linux system.
4) After successfully burning the Linux image of the development board to the NVMe
SSD, you can use the poweroff command to shut down. Then please pull out the TF card,
and then short press the power button to turn on, then the Linux system in
SPIFlash+NVMe SSD will be started.
5) After starting the system in the NVMe SSD, use the df -h command to see the actual
hard disk capacity
a. 128GB NVMe SSD
orangepi@orangepi:~$ df -h
Filesystem Size Used Avail Use% Mounted on
udev 3.8G 8.0K 3.8G 1% /dev
tmpfs 769M 1.4M 768M 1% /run
/dev/nvme0n1p2 118G 5.8G 111G 5% /
tmpfs 3.8G 0 3.8G 0% /dev/shm
tmpfs 5.0M 4.0K 5.0M 1% /run/lock
tmpfs 3.8G 16K 3.8G 1% /tmp
/dev/nvme0n1p1 256M 90M 166M 36% /boot
/dev/zram1 194M 9.9M 170M 6% /var/log
tmpfs 769M 60K 769M 1% /run/user/1000
tmpfs 769M 48K 769M 1% /run/user/0
b. 2TB NVMe SSD
orangepi@orangepi:~$ df -h
Filesystem Size Used Avail Use% Mounted on
udev 3.8G 8.0K 3.8G 1% /dev
tmpfs 769M 1.4M 768M 1% /run
/dev/nvme0n1p2 1.9T 4.1G 1.8T 1% /
tmpfs 3.8G 0 3.8G 0% /dev/shm
tmpfs 5.0M 4.0K 5.0M 1% /run/lock
/dev/zram2 3.7G 76K 3.5G 1% /tmp
To Next Page
Loading...