range Pi User Manual Copyright reserved by Shenzhen Xunlong Software Co., Ltd
31
12) After successful burning, the display interface of balenaEtcher is as shown in the
figure below. If a green indicator icon is displayed, it means that the image burning is
successful. At this time, you can exit balenaEtcher, and then pull out the TF card and
insert it into the TF card slot of the development board for use.
2.5. How to burn Linux image to eMMC
2.5.1. Using RKDevTool to burn the Linux image into eMMC
Note that all the following operations are performed on a Windows computer.
Note that the Linux image mentioned here specifically refers to the images of
Linux distributions such as Debian and Ubuntu downloaded from the Orange Pi
data download page.
1) The development board reserves the expansion interface of the eMMC module.
To Next Page
Loading...