Need help?Do you have a question about the ORANGE Pi 3B and is the answer not in the manual?
General| Ethernet | Gigabit Ethernet |
|---|---|
| Bluetooth | Bluetooth 5.0 |
| USB | 2x USB 2.0, 1x USB 3.0 |
| Power Supply | 5V/3A via USB-C |
| RAM | 4GB LPDDR4 |
| Storage | MicroSD card slot |
| Wireless | Wi-Fi 5 (802.11ac) |
| Video Output | HDMI 2.0 |
| Operating System | Android |
Detailed table of the Orange Pi 3B's hardware specifications, including master chip, CPU, GPU, NPU, VPU, etc.
Step-by-step guide on how to burn a Linux image to a TF card using a Windows PC and specific software.
Detailed instructions on using balenaEtcher software to flash a Linux operating system image onto a TF card.
Step-by-step guide for burning Linux images to a TF card using the RKDevTool on a Windows PC.
Instructions for burning Linux images to a TF card using Win32Diskimager, including formatting the card.
Instructions for burning Linux images to the eMMC module, detailing methods using RKDevTool and dd command.
Detailed steps to burn a Linux image into the eMMC module of the development board using RKDevTool on Windows.
Instructions for using the `dd` command to burn Linux images to SPIFlash and NVMe SSDs.
Guide on using RKDevTool to burn Linux images to SPIFlash and NVMe SSDs, detailing the process.
Guide on using SDDiskTool to burn Android images to TF cards, including formatting and selection steps.
Detailed instructions for burning Android images into the eMMC module using a USB2.0 port and RKDevTool.
Instructions for burning Android 11 images into eMMC storage using a TF card as an intermediary.
Instructions for using RKDevTool to clear the SPIFlash memory on the development board.
Guide on using the serial port for debugging, including connection instructions and platform-specific usage.
Steps to test the Ethernet port connectivity, including checking IP address and pinging external hosts.
Guide on connecting to WIFI using command-line tools like `nmcli` and `nmtui`.
Guide on setting static IP addresses for network interfaces using `nmtui` and `nmcli` commands.
Guide on setting up a WIFI hotspot in NAT mode using the `create_ap` script.
Instructions for creating a WIFI hotspot in bridge mode using the `create_ap` script.
Steps to remotely log into the development board's Linux system from an Ubuntu PC using SSH.
Guide on remotely logging into the development board's Linux system from a Windows PC using SSH via MobaXterm.
Instructions for uploading files from an Ubuntu PC to the development board using the `scp` command.
Instructions for uploading files from a Windows PC to the development board's Linux system using FileZilla.
Steps to test the HDMI output by connecting the development board to an HDMI monitor.
To Next Page