range Pi User Manual Copyright reserved by Shenzhen Xunlong Software Co., Ltd
32
Before burning the system to the eMMC, you first need to purchase an eMMC module
that matches the eMMC interface of the development board. Then install the eMMC
module to the development board. The eMMC module and the method of plugging into
the development board are as follows:
2) You also need to prepare a good quality USB2.0 male-to-male data cable
3) Then download the Rockchip driver DriverAssitant_v5.12.zip and MiniLoader and
the burning tool RKDevTool_Release_v3.15.zip from the Orange Pi data download
page
a. On the data download page of Orange Pi, first select the official tool, and then
enter the following folder
b. Then download all the files below
To Next Page
Loading...