Panasonic KX-NS500 - Page 196

CED Signal Fixation Detection Time
Specifies the minimum length of time required for the CED (called station identification) signal to be detected
by the PBX.
Value Range
50 ´ n (n=1–100) ms
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
CNG Signal Effective Detection Width 1 (ON) - SIP Extension
Specifies the length of time that the PBX detects the CNG signal for SIP extensions.
Value Range
20 ´ n (n=1–250) ms
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
CNG Signal Effective Detection Width 2 (OFF) - SIP Extension
Specifies the length of time that the PBX waits until another CNG signal is detected for SIP extensions.
Value Range
20 ´ n (n=1–250) ms
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
CNG Signal Fixation Detection Counter - SIP Extension
Specifies the number of times the CNG signal must be detected before the PBX proceeds the fax operation
for SIP extensions.
Value Range
1–3
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
CNG Signal Fixation Detection Pattern - SIP Extension
Specifies the CNG signal pattern to be detected before the PBX proceeds the fax operation for SIP extensions.
Value Range
Off, On
196 PC Programming Manual
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site