Panasonic KX-NS500 - Page 212

Setting parameters assigned to Remote SIP-MLT—NAT - NTP Server Port No.
Specifies the outside-facing port of the network gateway connected to the NTP server.
Value Range
1–65535
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
Feature Guide References
5.2.2.3 Simple Remote Connection
Setting parameters assigned to Remote SIP-MLT—NAT - Keep Alive Packet
Type
Specifies the type of Keep Alive packets to be sent out for remote connections.
Value Range
Register, Blank UDP, None
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
Feature Guide References
5.2.2.3 Simple Remote Connection
Setting parameters assigned to Remote SIP-MLT—NAT - Keep Alive Packet
Sending Interval Time (s)
Specifies the time interval between transmissions of the Keep Alive packet.
Note
• This interval must be shorter than the NAT binding time of the router. The default value is appropriate
in most cases.
• This setting is available only when NAT - Keep Alive Packet Type is set to "Blank UDP".
Value Range
10–60 s
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
Feature Guide References
5.2.2.3 Simple Remote Connection
212 PC Programming Manual
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site