Setting parameters for Networking Survivability, assigned to Remote
SIP-MLT—NAT - CWMP Server (HTTPS) Port No.
Specifies the outside-facing HTTPS port of the PBX-side network gateway for remote connections that is used
when the gateway specified in Setting parameters assigned to Remote SIP-MLT is not available.
Value Range
1–65535
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
Feature Guide References
5.2.2.3 Simple Remote Connection
Control Condition of Remote SIP-MLT—PERIODIC Ability
Specifies whether alive monitoring is performed for connected remote extensions.
Value Range
Enable, Disable
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
Feature Guide References
5.2.2.3 Simple Remote Connection
Control Condition of Remote SIP-MLT—PERIODIC Packet Sending Interval Time
(s)
Specifies the polling interval for alive monitoring when PERIODIC Ability is set to "Enable".
Value Range
30–3600 s
Maintenance Console Location
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
Feature Guide References
5.2.2.3 Simple Remote Connection
Echo Cancellation
The settings in this tab are for non-IP calls.
214 PC Programming Manual
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site
To Next Page
Loading...
