High Speed Pulse Dial—Break Width
Specifies the maximum length of the break signal in a high speed pulse dial. High Speed Pulse Dial—Pulse
% Break on this screen determines the value that can be specified here.
Value Range
12+ (4 ´ n) (n=1–15) ms
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
PC Programming Manual References
9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
High Speed Pulse Dial—Make Width
Specifies the minimum length of the make signal in a high speed pulse dial. High Speed Pulse Dial—Pulse
% Break on this screen determines the value that can be specified here.
Value Range
4 ´ n (n=3–15) ms
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
PC Programming Manual References
9.24 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Pulse Type
Selects the type of pulse dial transmission appropriate to your area.
Value Range
Normal, Sweden, New Zealand
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Option Card Equipment—Option 1 and Option 2
Indicates the type of the card that is installed on the LCOT card (reference only).
Value Range
None, Caller ID Card
PC Programming Manual 361
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
To Next Page
Loading...
