Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Feature Guide References
2.19.1 Caller ID
Caller ID—Caller ID (FSK) END Detection
Selects the method used to detect the end of Caller ID information.
Value Range
Length + Timer, Timer
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Feature Guide References
2.19.1 Caller ID
Caller ID—Caller ID (FSK) Header Examination
Enables the PBX to check the header of received Caller ID information. To enable this setting, Caller
ID—Caller ID Signalling on this screen should be set to FSK.
Value Range
Disable, Enable
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Feature Guide References
2.19.1 Caller ID
Caller ID—Caller ID (FSK) Detection Start Timer
Specifies the length of time that the PBX waits before attempting to detect Caller ID information, after receiving
a call. To enable this setting, Caller ID—Caller ID Signalling on this screen should be set to FSK.
Value Range
None, 80 ´ n (n=1–15) ms
Maintenance Console Location
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
PC Programming Manual 363
9.23 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
To Next Page
Loading...
