Maintenance Console Location
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port
ISDN Outgoing Call Type
Selects the method used to send dialled digits to the network.
Value Range
En-bloc: The PBX sends all of the dialled digits at once after the extension user completes dialling. The PBX
recognises the end of dialling when (1) # is dialled, if programmed, (2) a pre-programmed telephone number
is dialled, or (3) the inter-digit timer expires.
Overlap: The PBX sends dialled digits one at a time.
Maintenance Console Location
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port
PC Programming Manual References
9.1 PBX Configuration—[1-1] Configuration—Slot
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone—
Dial—Extension
Inter-digit (s)
10.9 PBX Configuration—[2-9] System—System Options—Option 2— ISDN en Bloc Dial—[#] as End of
Dial for en Bloc mode
11.1.4 PBX Configuration—[3-1-4] Group—Trunk Group—Dialling Plan
Feature Guide References
4.1.2.1 Integrated Services Digital Network (ISDN)—SUMMARY
ISDN Centrex
Enables the use of the telephone company’s ISDN Centrex Service features.
Value Range
Disable, Enable
Maintenance Console Location
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port
Feature Guide References
4.1.2.1 Integrated Services Digital Network (ISDN)—SUMMARY
Networking Data Transfer
Enables transmission of extension status data to connected PBXs in a network. This setting is only available
when
Port Type on this screen has been set to QSIG-Slave or QSIG-Master.
Value Range
Off, On
382 PC Programming Manual
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port
To Next Page
Loading...
