Dial—Extension Inter-digit (s)
Specifies the length of time within which subsequent digits must be dialled before the PBX sends a reorder
tone.
Value Range
1–250 s
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
Feature Guide References
2.5.2 Automatic Extension Release
Dial—Analogue CO First Digit (s)
Specifies the length of time within which the first digit of a telephone number must be sent to an analogue
trunk. If no digit is sent before this time expires, the PBX recognises end of dialling and stops muting the
caller’s voice over the analogue trunk.
Value Range
1–15 s
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
Dial—Analogue CO Inter-digit (s)
Specifies the length of time within which subsequent digits of a telephone number must be sent to an analogue
trunk. If no digit is sent before this time expires, the PBX recognises end of dialling and stops muting the
caller’s voice over the analogue trunk.
Value Range
1–15 s
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
Dial—Analogue CO Call Duration Start (s)
Specifies the length of time between the end of dialling and the start of the SMDR timer for outgoing analogue
trunk calls.
Value Range
0–60 s
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
PC Programming Manual 437
10.3 PBX Configuration—[2-3] System—Timers & Counters
To Next Page
Loading...
