During Conversation—DTMF Signal Length (ms)
Specifies the length of time that a DTMF signal is sent when a number is dialled from a PT or PS during a
conversation.
Value Range
80 ms, 160 ms, 240 ms, 320 ms
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
During Conversation—DTMF Inter-digit Pause (ms)
Specifies the length of time between DTMF signals when numbers are dialled in succession from a PT or PS
during a conversation.
Value Range
64 + 16 ´ n (n=0–15) ms
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
During Conversation—Pause Signal Time (s)
Specifies the length of the pause inserted when the PAUSE button is pressed during a conversation.
Value Range
1.5 s, 2.5 s, 3.5 s, 4.5 s
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
Feature Guide References
2.5.4.7 Pause Insertion
System Wireless—PS Out of Range Timer (s)
When the destination of an incoming call is a PS, specifies the length of time the PBX searches for the PS
before setting its status to Out of Range.
If "0" is assigned, the timer is controlled by the cell station.
Value Range
0–30 s
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
PC Programming Manual 451
10.3 PBX Configuration—[2-3] System—Timers & Counters
To Next Page
Loading...
