PC Programming Manual References
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port—Supplementary Service—
COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF (Rerouting), CT, CCBS, AOC-D, AOC-E, E911, 3PTY
Feature Guide References
4.1.2.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
4.2.4.2 Calling/Connected Line Identification Presentation (CLIP/COLP) and Calling/Connected Name
Identification Presentation (CNIP/CONP)—by QSIG
CLIR Set / Cancel
Specifies the feature number used to set or cancel CLIR, which suppresses the presentation of the caller’s
number to the called party.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port—Supplementary Service—
COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF (Rerouting), CT, CCBS, AOC-D, AOC-E, E911, 3PTY
Feature Guide References
4.1.2.2 Calling/Connected Line Identification Presentation (CLIP/COLP)
4.2.4.2 Calling/Connected Line Identification Presentation (CLIP/COLP) and Calling/Connected Name
Identification Presentation (CNIP/CONP)—by QSIG
Switch CLIP of CO Line / Extension
Specifies the feature number used to send either the CLIP number of the trunk in use (subscriber’s number)
or the extension to the network.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port—CO Setting— Subscriber
Number
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—CLIP— CLIP ID
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—CLIP— CLIP ID
472 PC Programming Manual
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
To Next Page
Loading...
