3. Web Maintenance Console Features
Clicking these buttons provides features for Web Maintenance Console, as follows:
Button Description
Save Data
Clicking this button will save any changes made to settings to the System Memory.
Programming changes that are not saved will be lost if the PBX is reset or is turned
off. Changes may also be lost if Web Maintenance Console is suddenly terminated
or the PC running Web Maintenance Console loses power unexpectedly. Be sure to
save the data periodically while programming, especially during long programming
sessions.
System
Information
Clicking this button displays the Web Maintenance Console software version,
copyright notices, and licences.
Note
Licence information is not displayed when programming in Off-line mode.
Logout
Clicking this button will save any programming changes to the PBX’s System Memory
and log you out of Web Maintenance Console. For more information, see
2.2 Logout.
Extension
List View
Clicking this button will display the Extension List View in a separate window. For
details, see 6.4 Tool—Extension List View.
Tab
Selection
Clicking this button will switch the tab display. There are two types of tab display, Tab
Mode and Single Mode. When Tab Mode is used, items clicked in the tree are
displayed in new tabs. When Single Mode is used, the current tab displays the clicked
item.
Note
• When the Menu button is clicked or when you log out in Tab Mode, all child
tabs are closed.
• When a parent tab is closed, all of its child tabs are closed.
• When Tab Mode is used:
– Up to 10 tabs can be opened including the parent tab.
– Tabs are displayed according to the tab settings of the browser
*1
used.
*1
To enable Tab Mode for Internet Explorer, select Tools ® Internet Options from the menu bar,
open the General tab and under Tabs, and then click Settings.
In the displayed window, check “Always switch to new tabs when they are created”, and then
select “Always open pop-ups in a new tab”.
Notice
Do not reload the web page during in Tab Mode. Doing so will close all child tabs.
4. Tree View
When the Maintenance Screen or Setup Screen is selected, the tree view is displayed. The tree view is
used to display PBX setting items. Setting items are listed in categories, and by clicking items in the tree,
setting items are displayed to the right in the settings programming area. Some tree items have
sub-categories with additional options and settings. Clicking a sub-category will open an additional layer
of settings. Below is a summary of the tree view menu items for the Setup Screen and the Maintenance
Screen.
PC Programming Manual 53
3.1 Home Screen
To Next Page
Loading...
