CLIP
When incoming caller information is sent through an ISDN line and the type of the network numbering plan is
International, National, or Subscriber, the caller’s number can be modified as programmed in the Modification
Tables assigned to the trunk group. The modified number will then be recorded, and it is used for sending to
the network as a CLIP number.
A maximum of 4 CLIP Modification Tables can be programmed. Select the desired table from the Modification
Table list.
Removed Number of Digits
Specifies the number of leading digits to be removed from the incoming caller’s number for each type of network
numbering plan.
Value Range
0–9
Maintenance Console Location
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification
PC Programming Manual References
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port— Calling Party
Number—Type of Number—Public, Private
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port— Called Party Number—Type
of Number—Public, Private
Feature Guide References
2.19.1 Caller ID
Added Number
Specifies the number to be added to the incoming caller’s number in the place of the removed digits for each
type of network numbering plan.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification
PC Programming Manual References
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port— Calling Party
Number—Type of Number—Public, Private
9.26 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port— Called Party Number—Type
of Number—Public, Private
566 PC Programming Manual
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification
To Next Page
Loading...
