Value Range
0.5 s, 1.0 s, 1.5 s, 2.0 s
Maintenance Console Location
11.12.1 PBX Configuration—[3-12-1] Group—VM (DTMF) Group—System Settings
Timing—Waiting Time before Sending VM DTMF Status Signal
Specifies the length of time that the PBX waits before sending the DTMF status signal to the VPS after the
VPS has finished dialling.
Value Range
0.5 s, 1.0 s, 1.5 s, 2.0 s
Maintenance Console Location
11.12.1 PBX Configuration—[3-12-1] Group—VM (DTMF) Group—System Settings
Others—Call Waiting on VM Group
Enables the queuing of calls when all extension ports of the VM (DTMF) group are busy. (Call Waiting tone is
not sent to any VM port.)
Value Range
Disable, Enable
Maintenance Console Location
11.12.1 PBX Configuration—[3-12-1] Group—VM (DTMF) Group—System Settings
Feature Guide References
2.2.2.4 Queuing Feature
Others—FWD to the VPS Sequence
Specifies which DTMF commands the VPS receives from the PBX when a call is forwarded to the VPS, so
that the VPS can answer the call either with a mailbox or in the AA service mode. It is also possible to send
no DTMF signal to the VPS.
Value Range
None, Answer by Mailbox, AA
Maintenance Console Location
11.12.1 PBX Configuration—[3-12-1] Group—VM (DTMF) Group—System Settings
624 PC Programming Manual
11.12.1 PBX Configuration—[3-12-1] Group—VM (DTMF) Group—System Settings
To Next Page
Loading...
