CO Line Access Number + Telephone Number
Specifies the telephone number (including the Trunk Access number) or feature number assigned to the
System Speed Dialling number.
Value Range
Max. 32 digits (consisting of 0–9, *, #, T [Transfer], [ ] [Secret], P [Pause], and F [Flash])
Maintenance Console Location
14.1 PBX Configuration—[6-1] Feature—System Speed Dial
Feature Guide References
2.6.4 Speed Dialling—Personal/System
2.19.1 Caller ID
CLI Destination
Specifies the CLI destination (extension) to which incoming calls from the programmed telephone number are
routed. If a Caller ID Modification Table is being used, the modified number must match the telephone number
above (CO Line Access Number + Telephone Number) in order for the call to be routed correctly.
Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
14.1 PBX Configuration—[6-1] Feature—System Speed Dial
PC Programming Manual References
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings—CLI for DIL—
CLI Ring
for DIL—Day, Lunch, Break, Night
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table— CLI Ring for DDI/DID—Day, Lunch,
Break, Night
Feature Guide References
2.1.1.4 Calling Line Identification (CLI) Distribution
2.19.1 Caller ID
PC Programming Manual 761
14.1 PBX Configuration—[6-1] Feature—System Speed Dial
To Next Page
Loading...
