TRG 01–TRG 64
Selects the trunk groups that connect to the carrier.
TRG 01–TRG 64
Enables each trunk group for each carrier. If a cell is highlighted in blue, that trunk group is enabled for use
with that carrier.
Value Range
OFF (white), ON (blue)
Maintenance Console Location
16.5 PBX Configuration—[8-5] ARS—Carrier
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
Authorisation Code for Tenant
Specifies an Authorisation code for each tenant. The Authorisation codes can be added to the user-dialled
number by specifying "A" command in
Modify Command on the Carrier tab.
Authorisation Code for Tenant—Tenant 1–Tenant 8
Specifies the Authorisation code of each carrier for each tenant.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Maintenance Console Location
16.5 PBX Configuration—[8-5] ARS—Carrier
Feature Guide References
2.8.1 Automatic Route Selection (ARS)
5.1.3 Tenant Service
796 PC Programming Manual
16.5 PBX Configuration—[8-5] ARS—Carrier
To Next Page
Loading...
