Feature Guide References
3.2.1.23 Intercom Paging
Fax Management
You can programme the system to automatically detect incoming fax calls and forward those calls to a fax
extension. You can specify a maximum of 2 fax extensions as the destination for faxes; if the main fax extension
is not available to receive a fax, the system will forward the fax call to the alternate fax extension.
Automatic Transfer of Incoming Fax Call
Specifies the detection and destination of incoming fax calls.
Note
The system can detect incoming fax signals during the first 30 seconds after it answers incoming calls.
Value Range
Disable, Transfer to Fax Extension
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Main Fax Extension No. (1-8 digits)
Specifies the extension number of the main fax machine.
Value Range
1–8 digits
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Alternate Fax Extension No. (1-8 digits)
Specifies the extension number of the alternate fax machine. When the main fax extension is busy or does not
answer within the time specified under
Fax No Answer Time (5-60s) , the system forwards the fax call to
the alternate fax extension.
Value Range
1–8 digits
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Fax No Answer Time (5-60s)
Specifies the length of time (in seconds) that the system waits for the main or alternate fax extension to answer
a fax call before taking other action, such as notifying the Fax Manager that the fax could not be received.
960 PC Programming Manual
24.4 UM Configuration—[5-4] System Parameters—Parameters
To Next Page
Loading...
