3 Features B
Features 3-21
FWD / DND (Call Forwarding / Do Not Disturb): Used to
program Call Forwarding, set Do Not Disturb.
HOLD: Used to place a call on hold.
INTERCOM: Used to make or receive intercom calls.
MESSAGE: Used to send a message or display current message.
MONITOR: Used for handsfree operation.
PAUSE: Inserts a pause in a speed dial number.
PROGRAM: Used to enter / exit programming mode.
RECALL: Allows you to disconnect the current call and originate
another call without hanging up (Recall). Sends a Register Recall
signal to the Central Office or a host PBX to access their features
(External Feature Access).
REDIAL: Used for Last Number or Automatic Redial.
SAVE: Used to store a dialed telephone number for Saved Number
Redial.
SHIFT: Used to access the second level of Soft button function.
Soft: Pressing a Soft button performs the function / operation
appearing on the bottom line of the display.
SP-PHONE (Speakerphone): Used for handsfree operation.
Pressing the button causes the telephone to switch between handset
and handsfree operation.
TRANSFER: Transfers a call to another extension or external
destination.
VOLUME: Used to adjust the ringer, speaker, handset and headset
volume and the display contrast.
Conditions • Certain buttons are equipped with light indicators (LED’s) to show
line or feature status.
• CO buttons can be classified according to the following three types:
Single-CO (S-CO) button / Group-CO (G-CO) button / Loop-CO (L-
CO) button
Programming References
Section 4, System Programming,
[005] Flexible CO Button Assignment
Station Programming.......................................................User Manual,
Flexible Button Assignment
Feature References None
Operation References Refer to respective operating instructions.
—User Manual
To Next Page
Loading...
