4.6 CO Line Programming
DID Table Number Assignment
430
4-102 System Programming
Description Assigns DID table number to each CO line group.
Selection • CO line group (TRG) number: 1 through 8,
( =all CO line groups)
• DID table number: 1 through 4
Default All CO line groups – Not stored
Programming 1. Enter 430.
Display: DID Table NO.
2. Press NEXT.
Display: TRK GRP NO?–>
3. Enter a CO line group number.
To enter CO line group number 1, you can also press NEXT.
Display example: TRG1:Not Stored
4. Enter a DID table number.
To change the current entry, press CLEAR and the new number.
5. Press STORE.
6. To program another CO line group, press NEXT or PREV, or
SELECT and the desired CO line group number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions This is the first and the basic programming for the DID feature. If the
assignment is changed here, it affects the other programmings ([431]
through [435]).
Feature References Section 3, Features,
Direct Inward Dialing (DID)
To Next Page
Loading...
