4.4 Timer Programming
First Digit Time
207
System Programming 4-63
Description Sets the maximum time allowed between the start of CO dial tone
and the first digit dialed on an outgoing outside call. If an
extension user fails to dial any digits during this time, the DTMF
receiver is released.
Selection Time (seconds): 5 through 120
Default 10 s
Programming 1. Enter 207.
Display: 1st Digit Time
2. Press NEXT.
Display example: Time: 10 sec
3. Enter the time.
To change the current entry, press CLEAR and the new time.
4. Press STORE.
5. Press END.
Conditions • This timer is used for toll restriction checking.
• You cannot leave the entry empty.
Feature References Section 3, Features,
Toll Restriction
To Next Page
Loading...
