4.4 Timer Programming
Call Duration Count Start Time
212
4-68 System Programming
Description Sets the number of seconds the system waits between the end of
dialing and the start of the SMDR timer for outgoing toll calls.
When the system has sent out all the digits to the central office and
this timer expires, the system starts counting the call. A display
telephone shows the elapsed time of the call. The starting time and
the duration of a call are recorded in the SMDR record.
Selection Time (seconds): 0 through 60
Default 0 s
Programming 1. Enter 212.
Display: SMDR Durat Time
2. Press NEXT.
Display example: Time: 0 sec
3. Enter the time.
To change the current entry, press CLEAR and the new time.
4. Press STORE.
5. Press END.
Conditions • The timer starts counting after all the digits are dialed. This timer is not
applied to incoming calls. The timer for incoming calls starts
immediately.
• You cannot leave the entry empty.
Feature References Section 3, Features,
Display, Call Information
Station Message Detail Recording (SMDR)
To Next Page
Loading...
