4.7 COS Programming
Account Code Entry Mode
508
System Programming 4-113
Description There are three account code modes: Option, Verified-All Calls and
Verified-Toll Restriction Override. This program determines the
mode to be used by each Class of Service (COS).
Option mode: The user can enter any account code, if needed.
Verified – All Calls mode:
The user must always enter a pre-assigned account code to make an
outside call.
Verified – Toll Restriction Override mode:
The user must enter a pre-assigned account code when the user
needs to override toll restriction.
Selection • COS number: 1 through 8, ( =all COS)
• Option / Verify – All (Verified-All Calls) / Verify – Toll
(Verified-Toll Restriction Override)
Default All COS – Option
Programming 1. Enter 508.
Display: Call Accounting
2. Press NEXT.
Display: COS NO?–>
3. Enter a COS number.
To enter COS number 1, you can also press NEXT.
Display example: COS1:Option
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another COS, press NEXT or PREV, or
SELECT and the desired COS number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all COS to one selection, press the key at step 3. In this
case, the display shows the contents programmed for COS 1.
• Station programming is used to define the Account Codes for the
Verified modes.
• Program [601] “Class of Service” is used to assign a Class of Service to
each extension.
Feature References Section 3, Features,
Account Code Entry
Toll Restriction Override by Account Code Entry
To Next Page
Loading...
Need help?
General
