D 3 Features
3-54 Features
• It is programmable to select the first display, meter or charge by System
Programming. To alternate the display, press the CO button.
Programming References
Section 4, System Programming,
[003] Extension Number Set
[004] Extension Name Set
[117] Charge Display Selection
[212] Call Duration Count Start Time
[419] CO Line Name Assignment
Feature References Section 3, Features,
CO Incoming Call Information Display
Operation References Not applicable.
Display, Extension Programmed Data
Description Allows the display proprietary telephone user to confirm the
features assigned on the buttons on the telephone. When it is on-
hook (that is, when the handset is on the cradle and the SP-PHONE
button is off), pressing a button displays the use of the button or the
information assigned to the button for five seconds.
Conditions • Display examples
(1) If REDIAL; SAVE; or One-Touch Dialing button is pressed, the
stored number is displayed: 950-1001PP12345&
(2) If the DSS or MESSAGE button is pressed, the extension
number and the name (if assigned) stored under the DSS button
or the source of the Message Waiting is displayed: 223: Tony
(3) If Account button is pressed, the display shows: Account
(4) If FWD/DND button is pressed, the selected feature assigned on
the button is shown as follows:
(a) If the Do Not Disturb feature is assigned: Do Not
Disturb
(b)If Call Forwarding- All Calls to extension 223 is assigned:
FWD(All) Ext223
(c) If Call Forwarding – Busy to extension 234 is assigned:
FWD(BSY) Ext234
(d)If Call Forwarding – No Answer to extension 345 is
assigned: FWD(NA) Ext345
(e) If Call Forwarding – Busy / No Answer to extension 200 is
assigned: FWD(B/NA) Ext200
To Next Page
Loading...
