Panasonic KX-T30865 - SMDR Format

4.10 Resource Programming
SMDR Format
801
System Programming 4-127
Description Used to match the SMDR output to the paper size being used in the
printer. Page length determines the number of lines per page. Skip
perforation determines the number of lines to be skipped at the end
of every page.
Selection • Page length (lines): 4 through 99
• Skip perforation (lines): 0 through 95
Default
Page length – 66; Skip perforation – 0
Programming 1. Enter 801.
Display: SMDR Format
2. Press NEXT to program page length.
Display example: Page Length:66
3. Enter the page length.
To change the current entry, press CLEAR and the new page length.
4. Press STORE.
5. Press NEXT to program skip perforation.
Display example: Skip Perf: 0
6. Enter the skip perforation.
To change the current entry, press CLEAR and the new skip
perforation.
7. Press STORE.
8. Press END.
Conditions • The page length should be four lines or more longer than the skip
perforation length.
• A title is positioned on the first three lines on every page.
• The programmed format becomes valid only if the EIA (RS-232C)
cable is connected. If a printer is already connected, disconnect it and
connect again. Otherwise the former format becomes valid.
Feature References Section 3, Features,
Station Message Detail Recording (SMDR)