4.2 Manager Programming
Operator / Manager Extension Assignment
006
4-26 System Programming
Description Assigns the jack number for a manager and / or operators. The
manager extension can perform system programming. The
operator has the ability to perform operator services.
Selection • OPE-1 (operator 1) / OPE-2 (operator 2) / MNGER (manager)
• Jack number: KX-TD816 – 01 through 16
KX-TD1232 – 01 through 64
Default Operator 1 – Jack 01;
Operator 2 and Manager – Not stored
Programming 1. Enter 006.
Display: Operator/Manager
2. Press NEXT to program operator 1.
Display: OPE-1:Jack01
To program another item, you can also keep pressing NEXT or PREV
until the desired one is displayed.
3. Enter a jack number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new jack number.
4. Press STORE.
5. To program another item, press NEXT or PREV.
6. Repeat steps 3 through 5.
7. Press END.
Conditions • Up to two operators and a manager can be programmed.
• In the case of KX-TD1232, jack numbers 01 through 32 are for the
Master System and 33 through 64 are for the Slave, if available.
• The manager cannot be assigned the jack number of the DSS Console
Port set in program [007] “DSS Console Port and Paired Telephone
Assignment.”
• If the assigned jack is in eXtra Device Port mode, the digital proprietary
telephone jack is treated as the manager / operator extension.
• If there is no operator or manager, press CLEAR at step 3.
Feature References Section 3, Features,
Manager Extension Operator
To Next Page
Loading...
