4.6 CO Line Programming
ISDN DDI Service Assignment
418
System Programming 4-99
Description Enables or disables ISDN DDI service per CO line.
Selection • CO line number:
KX-TD816 – 05 through 08, ( =all CO lines)
KX-TD1232 – 01 through 24, ( =all CO lines)
• Enable / Disable
Default All CO lines – Disable
Programming 1. Enter 418.
Display: ISDN DDI
2. Press NEXT.
Display: CO Line NO?–>
3. Enter a CO line number.
To enter CO line number 01, you can also press NEXT.
Display example: CO01:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • In the case of KX-TD1232, CO01 through CO12 are for the Master
System and CO13 through CO24 are for the Slave, if available.
• To assign all CO lines to one selection, press the key at step 3. In
this case, the display shows the contents programmed for CO01.
Feature References Section 3, Features,
Direct Dialing In (DDI)
To Next Page
Loading...
